How to Install Passenger Peg Block Offs on Your Triumph

James from British Customs installs passenger peg block offs on a 2022 Triumph Street Twin.

Model: 2022 Triumph Street Twin (fits most Triumph liquid-cooled models, 2016+ — see fitment table below)

Product: Passenger Peg Block Off

Time: 15-20 min

Please note: Installation should only be performed by someone experienced with motorcycle maintenance and comfortable using the tools listed above. If you are not confident in your ability to complete this install safely, we strongly recommend having it performed by a qualified motorcycle mechanic. British Customs provides this guide as a reference only and assumes no liability for injury, damage, or improper installation resulting from its use.

Tools You'll Need

• 5mm hex bit
• 6mm hex bit
• 12mm wrench
• Torque wrench
• Small flathead screwdriver or pick

Torque Specs

Step 1: Remove the Passenger Peg (0:26)

Pry off the retaining clip with a small flathead screwdriver or pick, then push the pin up. There's a small ball bearing and spring inside — keep a hand underneath so you don't lose them. Remove the peg with a 6mm hex bit and 12mm wrench.

Step 2: Install the Block Off Plate (1:22)

Push the block off plate's screw back through the mounting hole and reinstall the nut you removed earlier. Tighten with a 5mm hex and 12mm wrench, then torque to 24 Nm.

Step 3: Repeat on the Other Side (2:03)

Same process: remove the clip, pin, and peg (6mm hex, 12mm wrench), install the block off plate and nut, then torque to 24 Nm with the 5mm hex and 12mm wrench.

Questions about your install? Contact British Customs support, or check out more install guides for your Triumph.

This guide was created from James's install walkthrough video and is provided as a reference only. British Customs assumes no liability for injury, damage, or improper installation resulting from its use. If you're not confident performing this install yourself, have it done by a qualified motorcycle mechanic.